Attaching The Sanding Paper Pad To The Sanding Pad Holder; On/Off Switch; Speed Controller; Maintenance And Cleaning - Westfalia 81 25 09 Bedienungsanleitung

Attaching the Sanding Paper Pad to the Sanding Pad Holder

The sanding pad holder is equipped with a hook and loop pad, so you easily and
conveniently can change the sanding paper pads (4). Keep the adhesive fabric of
the sanding pad holder free from dirt and dust, so the adhesive fabric will work as
desired.
1. Position one corner of the sanding paper pad to the pad holder and firmly
press it down. For optimal dust extraction, make sure the holes in the sanding
paper pad match the holes in the sanding pad holder.
2. To remove the sanding paper pad, grasp one edge and pull it off the sanding
pad holder.

ON/OFF Switch

1. To switch on the multi-function tool, push the ON/OFF switch (1) forwards.
2. To switch off the tool, pull the ON/OFF switch back.

Speed Controller

With the speed controller (3) you can adjust the speed according to application.
Select the appropriate speed setting and make sure the multi-function tool does
not become overloaded and stops running.
Turn the speed controller (3) steplessly to the desired setting to increase or
decrease the speed. The controller can be adjusted from 1 – 6. The speed rate
can be changed during operation as well.
Hint: The required speed rate for cutting resp. sanding a workpiece depends on
the material that you are going to process. For best performance, make some
practical tests.

Maintenance and Cleaning

The multi-function tool does not require special maintenance. Do not
disassemble it and do not try to repair it yourself.
Use a moist cloth to clean the multi-function tool. Do not use aggressive
chemicals or abrasives.
Operation
13