Rear Panel Features - Bell MMP11 Handbuch

Rear Panel Features

Fuse
The mains fuse is located in a click-in compartment below the mains so-
cket. The correct type of fuse depends on the selected mains voltage:
115V: 500mA (T)
Blown Fuse
Reasons may a short circuit, wrong setting of input voltage or another
technical problem. Should changing the fuse not help, the player must be
serviced by BELL or an authorized BELL service partner. Do not attempt to
open and service the player. High voltage inside!
Mains voltage selection
Factory setting is 230VAC. If necessary, the unit may be set to 115VAC
by operating the red-slide switch. (Any wrong setting of the input voltage
may cause severe damage to the unit).
Outputs L+R (CINCH / RCA) unbalanced RCA outputs Left + Right
Outpults L+R (XLR) balanced. XLR Pins: 1=GND, 2=(+), 3=(-)
GND Lift
In case of audible hum from the speakers (PA) system, the GND Lift may
be used to eliminate ground loops.
Technical Specifications Technical Specifications
Media:
MP3 Decoder:
Anti shock:
Over sampling rate:
Sampling frequency:
Frequency response:
THD:
Signal to noise ratio:
Dynamic range:
Power supply:
Dimensions / weight:
230V:
oder
CD / USB / SD Card
16 to 48kHz sampling frequency
bit rate 32 to 320kbps
40 sec. buffer memory
8 times
44.1 kHz
20Hz to 20kHz
less than 0.05%
100dB
96dB
115 or 230VAC, 60/50Hz
482x44x270mm, 3.2kg (approx)
GND
LIFT
250mA (T)