First Use - Moulinex DDI101 Bedienungsanleitung

IFU_MIXER_EO_0828404_Mise en page 1 19/07/10 10:47 Page15
• Do not touch the moving parts.
• Do not dismantle the appliance yourself. Simply carry out the usual care
and cleaning steps as advised.
• For your safety, use only accessories and spare parts designed for your
appliance.
• Care must be taken when handling the sharp blades, when emptying the
bowl or when cleaning.
Changing the power cord.
If the power cord or the plug are damaged, do not use the appliance. In
order to avoid any danger, have them replaced by an approved service cen-
tre (see list in the service manual).
This product has been designed for domestic use only. Any commercial
use, inappropriate use or failure to comply with the instructions, the ma-
nufacturer accepts no responsibility and the guarantee will not apply.

FIRST USE

Before using for the first time, wash the mixer attachment (C) in and all of
the accessories hot water and use washing-up liquid, rinse and dry carefully.
Mixer attachment
• Screw the mixer attachment (C) onto the motor unit (A). Turn it as far
as possible. (fig. 4)
• The recipient you use must not be filled to more than 50cl (15oz) to
avoid overflowing. The preparation must at least cover the flared bottom
of the mixer attachment to ensure that the mixer operates efficiently.
• Remove the cooking recipient from the source of heat when mixing hot
preparations. Do not hesitate to move the mixer attachment (C) around
in the recipient to get optimum results.
• Do not operate the appliance for more than 20 seconds consecutively,
otherwise let it cool down.
• Place the hand blender shaft in the mixture, immersing only the head,
turn the appliance on and leave to blend.
• There is no need to pound the mixture to achieve a good result.
150ml mini mincer
• Before using the 150 ml mini mincer, carefully place the cutter (E2) into
the bowl (E3) on the central drive. Place the ingredients in the bowl. Fit
the cover (E1) onto the bowl and then fit the motor unit (A) onto it.
(fig. 5)
• To remove the accessory after use, remove the motor unit (A) from the
15
EN