Product Description - oneConcept 10006582 Anschluss- Und Anwendungshinweise

• The heater is for indoor use only. Do not insert or allow foreign objects to enter any ventila-
tion or exhaust opening, as this may cause an electric shock or fire, or damage the heater.
• Be sure that no other appliances are plugged into the same circuit with your heater, as
circuit overload could occur.
Hints on Use
• To avoid drying out the material in shoes/boots with fragile materials, do not let the shoe
and boot dryer run for too long.
• It is better to dry the shoes in 2 shorter periods.
• In order to avoid overheating, do not cover the heater.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
• The heater must not be located immediately below a socket-outlet.
• This appliance is not intended for use by persons (including children) with reduced physi-
cal, sensory or mental capabilities unless they have been given supervision or instruction.
• Children should be supervised to ensure that they do not play with the appliance.
Hints on Overheating Protection
In case of heat accumulation a protective device against overheating will switch off heating
automatically. If the overheating protection has switched off, please proceed as follows:
1. Switch off the appliance (pull out the plug).
2. Remove the overheating cause (e.g. covered air-intake grid inhibition of air circulation,
dust fluff etc.)
3. Let the appliance cool down for a few minute.
4. Then the appliance can be switched on again.
1. Grid
2. Timer knob
3. Lamp
4. Thermostat knob
5. Knob
6. Hose
7. Wall mounting
bracket
8. Hand on board
9. Expanded tube
10. Screw

Product Description

7