AVLink PBH10 Bedienungsanleitung Seite 2

long-press to decrease the volume. In FM mode short-press to go to the preceding station.
4. Next track/volume up
While in Bluetooth or MP3 mode short-press to move to the next track and long-press to increase the
volume. In FM mode short-press to go to the next station.
5. Power/play/pause/pair/scan
Press and hold this button for 2-3 seconds until an audible alert for on/off is heard. By default, the PBH10
will go into Bluetooth pairing mode and the LED indicator will flash blue and green. Once Bluetooth
connection has been made a constant blue light will be displayed. If you need to pair again press and hold
the button for 2-3 seconds. If you are asked for a pairing code the device is listed as AV:Link-PBH10 and
the code is 0000. While in Bluetooth or MP3 mode short-press to play and pause the current track.
While in FM radio mode (see section 2 above) short-press to perform a channel scan. The 12 strongest
signals will be stored automatically. Channels can then be selected by pressing buttons 3 and 4.
6. Micro USB port
Insert the USB cable provided to charge the unit. On first use please ensure you fully charge the
headphones. Whilst charging the LED will glow red and once it's fully charged it will go out. On low power
the LED will flash red, please recharge the unit at this point.
7. 3.5mm jack port
Also provided with the unit is a 3.5mm jack cable which can be used with the headphones by connecting
to any device with a 3.5mm socket.
8. Micro SD card slot
Insert a micro SD card for use in MP3 mode, the maximum capacity is 32GB.
This product is classed as Electrical or Electronic equipment and should not be disposed with other household or commercial waste at
the end of its useful life. The goods must be disposed of according to your local council guidelines.
Controls & Functions
1. Phone connect/disconnect
When in Bluetooth mode, press this button to answer an incoming
call or hang up when you have finished. Alternatively, long-press
this button while content is playing, and it will automatically call
your last logged number. If you receive a call while content is
playing, the unit will pause your current track and allow you to
answer or reject the call. On completion of the call it will continue
playing your current track.
2. MODE/EQ
Long-press to alternate between Bluetooth, FM radio or MP3 mode.
See section 5 below for FM tuning.
Please note MP3 mode will only function when a micro SD card is
inserted. While any content is playing short-press to use the
equalizer function and alternate between
natural/pop/rock/jazz/classical/bass-boost modes.
3. Previous track/volume down
While in Bluetooth or MP3 mode short-press to go back a track and
Errors and omissions excepted.
Copyright© 2018 AVSL Group Ltd.
Wireless Bluetooth® Headphones User Manual