Starting Operation - Bosch GLI 9,6 V PROFESSIONAL Bedienungsanleitung

OBJ_DOKU-4516-001.fm Page 8 Thursday, October 12, 2006 8:59 AM
Changing the Light Bulb (see figure A)
Before any work on the cordless worklight,
remove the battery.
Exercise caution when changing the light
bulb! Do not touch the hot light bulb. Allow
the light bulb to cool down for at least 10 min-
utes. Danger of burns from the hot light bulb.
Note: Use a soft cloth for changing the light bulb. Make
sure not to touch the glass bulb with your bare fingers.
Otherwise, the light bulb can become damaged.
• Turn the screw cap 1 in anticlockwise direction and
remove it.
• Remove the protective lens 8 and the reflector 9.
• Turn the light bulb 10 approx. 90° in anticlockwise
direction and pull it out. A spare light bulb 11 is
stored in the base of the housing.
• Insert a new light bulb 10 and turn it approx. 90° in
clockwise direction until it is locked.
• Insert the reflector 9 into the lamp head without
damaging the light bulb 10.
• Insert the protective lens 8 into the screw cap 1 and
screw the screw cap onto the lamp head 3. Ensure
that all parts are properly seated.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch O-pack batteries with
the voltage given on the type plate of your
cordless worklight. Usage of other batteries can
cause injuries and lead to danger of fire.
Insert the charged battery 6 into the handle until it can
be felt to engage and faces flush against the handle.
Switching On and Off
To switch the cordless worklight on, press the On/Off
switch 5 upward.
To switch the cordless worklight off, press the On/Off
switch 5 downward.
8 | English
Changing the Position of the Reflector
The lamp head 3 can be swivelled upward to a maxi-
mum of 90° by turning in anticlockwise direction.
Changing the Illuminating Beam/Focal Length
By turning the adjustment ring 2, the illuminating beam
as well as the focal length of the reflector can be
changed.
Operating Instructions
At low temperatures, the luminous efficiency may be
lower and the lighting duration shorter.
When using Bosch NiMH batteries, the performance
capability is limited at temperatures below – 10 °C.
Soft Grip
The gripping surface 4 (soft grip) reduces the danger
of slipping and thereby improves the grip on the cord-
less worklight and the handling.
1 609 929 K47 • 12.10.06