RIDGID 550 Gebrauchsanleitung Seite 2

550, 530-2
Operating Instructions
WARNING!
instructions and the ac-
companying safety booklet
carefully before using this equip-
ment. If you are uncertain about
any aspect of using this tool, con-
tact your RIDGID distributor for
more information.
Failure to understand and follow all
instructions may result in electric
shock, fi re, and/or serious personal
injury.
SAVE THESE INSTRUCTIONS!
Technical Data:
Model: ..................................... 550
Absorbed power (W): ............ 1200
Strokes per minute: .......800-2400
Radio interference suppression according to
VDE 0875
Recommendad Cutting Speeds:
Wood: ..........................................................6
Plastics: ................................................... 5-6
Steel/Metals: ............................................ 3-4
Brass: ......................................................... 4
Copper: ....................................................... 4
Aluminium: .................................................. 6
GB
Read these
530-2
1300
0-2400
Ridge Tool Company
550, 530-2
Caution
Before plugging the unit into the power socket, check
the following:
• Voltage: The voltage on the rating plate must be
the same as that of the supply.
• Switch: The machine must be switched off
(Fig. 1.1, 1.2).
• Tool: Use appropriate saw blade for material.
Replace blade when worn.
To saw pipe
Attach appropriate pipe holder and blade (see RIDGD
catalogue) locating pivot shaft of pipe holder in hole of
saw gear housing.
Set speed (Fig. 2) according to material (see chart
inside carrying case).
Orbital action
Set "ON" for fast cutting (Fig. 3). Set "OFF" for precise
cutting and when starting to cut metal (Fig. 4).
Important
Do not overload the saw by forcing the blade into the
work. Excessive pressure will wear blades faster and
may damage the saw.
1