oneConcept 10030737 Handbuch Seite 11

1. First, find a stable surface near an electrical
outlet before starting. Make sure the cord is
away from any water source. It is acceptable
to use an extension cord if needed.
2. Plug in unit at the OFF position.
3. Turn unit to ON position and allow it to run
for at least 5 minutes before adding hard
candy. If using sugar, allow appliance to run
for at least 10 minutes before adding sugar.
This will allow the turnplate to heat.
4. Turn unit OFF and place no more than two
pieces of hard candy or one scoop of fla-
voured sugar (1 tbsp.) into the turnplate.
If using candies, make sure they are evenly
placed on either side of the turnplate (see
image below).
5. Switch to ON position.
6. When you see the cotton candy web begin,
collect the cotton candy on the cone by hold-
ing the cone vertically. Rotate the cone with
your fingers while you circle the bowl.
7. Once cotton candy has collected on the
cone, hold the cone in a horizontal position
over the turnplate while still rotating the
cone with your fingers. Continue turning the
cone with your fingers while the cone is in
the horizontal position and move from side
to side making sure to collect all the cotton
candy.
8. Repeat above steps by adding another
measure of candy or sugar into the turnplate
and starting again. The cotton candy should
flow more quickly as the unit is sufficiently
warm.
9. DO NOT overfill the turnplate by adding
more than two candies or 1 tbsp. of sugar at
a time. This will cause clogging and unit will
not work properly.
10. By following these simple instructions, using
your machine will be a fun experience for
kids of all ages and will bring the excitement
of a carnival to any occasion.
Use
11