6: Loading Negative Film - Chal-Tec Klarstein Combo Benutzerhandbuch

6: Loading Negative film

Negative film properties: The light and shade,
color of the Negative is exactly inverted from the
original image.
Place the film onto the holder with the glossy
side facing up and the image should be upright.
Use the tabs in the holder to align the negatives
film.
Note: Handle negatives with care. Any dust,
scratches or fingerprints will show up on your
saved images. If possible wear cotton gloves
when handling negatives. It is recommended
to use compressed air to remove any dust on
the negatives. This is not included with the film
& photo scanner but can be purchased from an
office or electronics supply retailer.
Close the negative holder and press the edges
so that it locks in place
Hold it in the position as shown in the film &
photo scanner.
Insert the negative holder into the slot on the
right side of the film & photo scanner as shown.
Film Holder: The design of the film holder
follows ISO standard. In some cases the holes
on the film will not match exactly to alignment
of the holder, as this is caused by using non-
standardized film.
I S O - - I n t e r n a t i o n a l O r g a n i z a t i o n f o r
Standardization
7