B.A. International SuPreme S5 BA190030 Betriebsanleitung Seite 5

9. USE
FILLING WATER
• Loosen the cap (safety valve).
• Fill the water by plastic funnel and do not exceed maximum water level.
• Tighten the cap.
• Place the rod supporting the steam gun in its seatings.
• Set the switch to on.
• Wait for the start light to go on (about 10-15 minutes).
• Push the button to activate the steam supply.
During use
• Check the water level on the visual indicator.
• Never open the safety cap when steamer is switched on.
• Condensation inside the pipe generates a small quantity of water which will exit at the fi rst
steam request.
• Check the water quantity by the glass level and if necessary fi ll it (fi ll it when the machine is
switched OFF).
• Never use the machine with the water under the minimum level. If the water is under the level
the light will become red. It is very important to pay attention to the level of the water.
If the minimum level of water is reached and you still require to use the machine, do so as
follows:
› Switch off and wait several minutes.
› Loosen the cap little bit – ¼ turn and wait for the pressure to be released. Let the remaining
pressure escape.
› Remove the cap carefully.
› Fill the boiler with hot water.