Herunterladen Inhalt Inhalt Diese Seite drucken

Safety And Emc Instructions; Installation - Power Walker VFI 1000 TG Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Safety and EMC Instructions

Please read carefully the following user manual and the
safety instructions before installing or operating the unit!

1.1 Installation

★ See installation instructions before connecting to mains power.
★ Condensation may occur if the UPS is moving directly from a cold
to a warm environment. The UPS must be absolutely dry before
being installation. It is recommended to have an acclimatization
time at least two hours.
★ Do not install the UPS near water or in damp environment.
★ Do not install the UPS where it would be exposed to direct sunlight
or near heat.
★ Do not connect appliances or items of equipment which would
overload the UPS (e.g. laser printers, etc.) to the UPS output.
★ Place cables properly to avoid someone treaded or tripped over
them.
★ Assure to connect with the earth reliably.
★ Connect the UPS only to a socket outlet which is earthed
shockproof type.
★ The building wiring socket outlet (shockproof socket outlet) must
be easily accessible to close to the UPS.
★ With the installation of the equipment, the sum of the leakage
current of the UPS and the connected load does not exceed
3.5mA.
★ An additional circuit breaker or fuse with rating 16A and breaking
capacity 3kA shall be used between power source and input when
installation this unit.
★ Do not block ventilation openings on the UPS's housing. Ensure
the air vents on the front, side and rear of the UPS are not blocked.
-1-

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis