Machine-Specific Safety Instructions; Operating Personnel Requirements; Workplace Safety; Electrical Safety - Baier BSM 287 Original Bedienungsanleitung

EN
2.6 Machine-Specific Safety
Instructions
2.6.1 Operating personnel
requirements
•
People below the age of 16 may not use the
machine.

2.6.2 Workplace safety

•
Do not use the power tool near flammable
materials.
Sparks could ignite these materials.
•
Avoid causing situations where other people
can stumble or trip.
Tripping over cables can cause serious injuries.
•
Avoid dust accumulation in the workplace.
Dusts can easily ignite.
•
Ensure adequate ventilation in closed
rooms.
Risk due to dust and impaired vision.

2.6.3 Electrical safety

•
The BSM 2863 – 110 V power tool may only
be operated with a perfectly functioning
PRCD personal protection switch (see page
29).
•
Before starting up the power tool you
must ensure that a perfectly functioning
protective earth (PE) conductor is available.
•
Before each use, check the power tool,
connection cable and plug for damage.
Damaged equipment is dangerous, and no
longer safe to use.
•
Note the mains voltage! The power source
voltage must match the details given on the
rating plate of the power tool.
•
If using the power tool with mobile
generators, loss of power or atypical
behaviour on switching on is possible.
•
Do not use the power tool if the cable is
damaged. Do not touch the damaged cable
and disconnect the mains plug if the cable is
damaged while you are working.
Damaged cables increase the risk of an electric
shock.
•
Only use extension cables suitable for the
machine's power consumption and which
have a minimum core cross-section of
1.5 mm 2 . If you use a cable drum, always
completely unwind the cable.
The rolled up cable can heat up and start to
burn.
| 24 |
•
Regularly clean the ventilation slots of your
power tool by blowing it out. Never use
liquids. Never insert screwdrivers or any
other objects into the ventilation slits. Do
not cover the ventilation slits.
The motor fan draws dust into the housing and
a large accumulation of metal dust can cause
electrical hazards.
•
External electromagnetic interference (e.g.
mains voltage fluctuations, electrostatic
discharges) can cause the power tool to
switch off automatically.
In this case, switch off the power tool and then
switch it back on again.

2.6.4 Safety of people

•
Wear personal protective equipment and,
depending on the work situation, use:
Full-face protection, eye protection
or safety glasses/goggles, hard hat
and special apron
Protect yourself against debris thrown
up by wearing a hard hat, safety
goggles or face protection and wear an
apron, if necessary.
Hearing protection
The typical A-weighted sound
pressure level of this power tool is over
85 dB (A) while working with the tool.
If you are exposed to loud noise for
lengthy periods, there is a risk of
hearing damage or even hearing loss.
Anti-vibration safety glove
At a release value A (8) for arm-hand
vibrations of over 2.5 m/s
of anti-vibration safety gloves is
recommended.
Half-mask with filter
Fine dust can be produced when dry
substances are added during mixing.
The risk of silicosis is very high when
mixing materials containing quartz,
therefore a suitable half-mask with
filter must be worn.
Asbestos-containing material may
only be machined by specialists.
Non-slip safety footwear
2 , the wearing