Intended Use; Operation - Wolf Garten ABC 36-03 Originalbetriebsanleitung

Safety information
General safety information
¾ Before initial use, perform a visual
inspection of the device to check
for damage.Prior to use any damage
must be repaired by a qualified expert
or workshop.
¾ Do not use any damaged, defective
or deformed power packs.

Intended use

The device is intended for charging power
packs of type ABP 36-03 and ABP 36-05;
these are authorised by the manufac-
turer. Any other use is classed as an
unintended use. The user is liable for any
damages arising from unintended use.

Operation

Injuries or material damage.
¾ Note the mains voltage.
¾ The voltage of the current
source must match
the information on the
identification plate of the
device.
Note
The power pack becomes hot
during operation.
Charging (Fig. A)
Plug the charger into a suitable socket
Î
A1.
3 The LED goes red.
Plug the power pack into the charger
Î
A2.
3 Charging starts and the LED goes
green.
ABC 36-03
Safety information
CAUTION !
¾ Do not charge any third party
power packs.
¾ Never try to charge non-
rechargeable power packs.
¾ Do not cover the ventilation slits of
the charger. Otherwise the charger
may overheat and no longer function
correctly.
¾ Repairs must only be performed by
a qualified expert or workshop
Note
After approximately 45 minu-
tes the 3 Ah power pack is 80
% charged and after about 70
minutes it is fully charged. After
approximately 80 minutes the
5 Ah power pack is 80 % charged
and after about 110 minutes it is
fully charged.
LED charge state indicator
LED status
Steady red
Flashes green
Steady green
Quick flashing red
Slow flashing red
Steady red
Note
To protect the power pack and
ensure a long service life, the
charger switches off as soon as
the power pack is fully charged.
Meaning
Mains voltage con-
nected.
Charging.
Charging completed.
Power pack possibly
defective. Arrange for
testing of the power
pack by a specialist
workshop.
Power pack too hot.
Charging starts automa-
tically if the operating
temperature is correct.
Power pack is not char-
ging. Power pack is not
correctly inserted or the
contacts are dirty.
EN
11