nemaxx WLS-01 Gebrauchsanleitung Seite 8

TESTING MODE
1. Wind speed testing mode
When the sensor is in wind speed real-time testing mode, the figures reflect the current
wind speed outside.
For example, the figure "1.0" represents real wind speed is 10 km/h outside.
4
1. Press the left button quickly four times.
2. The dot in the middle is on.
3. Short press the right button once to leave the wind speed testing mode.
2. Light intensity testing mode
When the sensor is in light real-time testing mode, the figures reflect the current light
intensity outside.
For example, the figure "10." represents real light intensity is 10000 Lux outside.
4
1. Press the right button quickly four times.
2. The dot at the the right corner of the LCD is on.
3. Short press the left button once to leave the light intensity testing mode.
NOTE
In the light intensity testing mode, the numerical value displays the light intensity from
1000 to 100000lx.
It shows "00." below 1000lx, and "99" above 100000lx.
For example, the figure "12." represents 12000lx.
It will return to the initial interface 3 minutes after if there is no further operation done to the
sensor.
EN
8
KEN001WLS
v01 • 17.05.2017
1
1