Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
FIG. 6a
FIG. 6b
Place the cable guide on the roof marking the outline, drill a suitable hole to let the
cable throug h (see Fig.6a), prepare the surfaces for glueing as described here above
to install the solar panel. Insert the two M4x14 stainless steel screws in the cable guide
base, and use the special applicator to apply a TEROSON MS930 glue bead around the
base, see Fig.6b, then position the base in the required position and press firmly.
Complete the installation according to the indications in Figs. 6c.
FIG. 6c
Wait for the glue to set (approx. 24h) before tightening the cable guide
cap nut.
Provide plastic cable conduits for the cables, to prevent them hitting the roof during
vehicle travelling.
Choose a suitable location for the controller module and the batteries, as the cable
routing is influenced by these parts' positioning.
Only move the vehicle after the glue has set.
5
Werbung
