SEA GHOST 50 Bedienungsanleitung

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
GB
INFRARED BEAM PHOTOCELL GHOST 50
General
The 23102080 photocell has been designed to be compact and to provide speed of installation, operation and
durability. Unit size: (57x85x88 mm). The high resistance acrylic plastic provides classic styling plus the
strength required to stand the test of time.
The 23102080 Photocell Kit Consists of:
1 No. 23102080 Photocell Receiver
1 No. 23102080 Photocell Transmitter
1 No. Fixing Kit
4 No. cover-screw cap
1 No. Set of fitting instructions
Technical Characteristics
Range:
Signal:
Wave length:
Modulation Frequency: 400 Hz
Supply Voltage:
Absorbed Current:
Temp. Operating Range
Relay Contact Rating: 1A max @ 24V
Humidity:
INSTALLATION
Transmitter
- Feed the cable in through the back of the unit
and make connections as shown in figure 2.
- Adjust the cable within the unit to eliminate
any surplus.
- Fix the unit as shown in figure 3.
- Seal the cover & cable entry to prevent insect
infestation.
Receiver
- Feed the cable in through the back of the unit
and make connections as shown in figure 2.
- Adjust the cable within the unit to eliminate
any surplus.
- Fix the unit as shown in figure 3.
- Take care in positioning, verify the alignment
and height will be the same as that of the
transmitter.
- Seal the cover & cable entry to prevent insect
infestation.
Operational set-up and testing
- Power-up the photocells (12-24 Volts ac/dc)*.
Cod. 67410605
®
SEA S.r.l.
DIREZIONE E STABILIMENTO:
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. 0861 588341 r.a. Fax 0861 588344
30 m (exterior use)
Modulated infrared
880 mm
12 - 24 Vac/Vdc
Tx: 30 mA Rx: 30 mA
-15° C / +60° C
from 5% to 90% no condensation
English
(cod. 23102080)
JP1 JP1
OFF = 24V OFF = 24V ON = 12V ON = 12V
*Notice: Check the photocells power supply voltage
carefully and set the jumper (JP1) correctly.
If the photocell is wrongly powered with 24V with JP1
plugged in (ON), it can seriously damage.
Base
Ring
Ring
Rev. 01 - 10/2008
http://www.seateam.com
e-mail:seacom@seateam.com
57
Fig. 1
38
JP1
1 2
JP1 JP1
Fig. 2
Ring
Fixing screw
Electric circuit
Fixing screw
Cap
Fig. 3
Cap lock screw
55
33
38
JP1
1 2 3 4 5
Cap lock screw
Cover-screw
cap
Pag. 5/11