Installing The Unit - Ontech GSM 9025 Schnellstartanleitung

Welcome
Thank you for choosing an Ontech GSM 9025. We hope that the product
will satisfy your needs and that you will find this manual easy to handle
and that it guides you in an appropriate way. Read the whole manual
carefully before you start using the product.
If you have futher questions, please visit our web site at www.ontechgsm.
com, where you can find more information. The site is often updated
with tips and news.
SIM Card
In order to use the unit you must have a SIM-card for mobile telephones
(GSM) and access to a mobile phone. Prepaid card can be used. You must
deactivate the pincode on the card and also remove the welcome mes-
sage if there is one. You do this by making a voice call.
NB. SIM-card from network operators using only the 3G net will not work in
the unit.

Installing the unit

•
Attach the antenna on the SMA antenna contact
•
Place the unit on the place of your desire and attach it by using
screws in the two holes. The antenna shall point down. Open the
unit by unscrew the two screws on the left and right sides.
•
Pull the "hood" approximately 5 cm or until you can see the
SIM card holder. Pull carefullyand not too long because there is a
risk of the flat cable is loosened from its contact. If this happens
see the reference manual www.ontechgsm.com/en/support/refer-
ence9025en.pdf.
•
Install the SIM card.
•
The upper part of the SIM card holder is moved to downuntil
you hear a click.
•
Fold up the upper part of the SIM card holder.
•
Place the SIM card in the upper part. The cut corner of the SIM
card shall be positioned in the upper left corner when the up-
per part of the card holder is folded back.
•
Fold back the upper part.
•
Lock the upper part by moving it to up until you hear a click.
•
Open the screw cap by screwing it to the left.
- 9 -