Electrical Installation - Bibby Scientific Stuart HM50C Bedienungsanweisung

Heating Mantle
HM50C, HM100C, HM250C, HM500C and
HM1000C
Instructions for use
introduction
Thank you for purchasing this piece of Stuart
equipment. To get the best performance from
the equipment, and for your own safety, please
read these instructions carefully before use.
Before discarding the packaging check that all
parts are present and correct.
This equipment is designed to operate under the
following conditions:-
❖ For indoor use only
❖ Use in a well ventilated area
❖ Ambient temperature range +5°C to +40°C
❖ Altitude to 2000m
❖ Relative humidity not exceeding 80%
❖ Mains supply fluctuation not exceeding 10%
❖ Overvoltage category II IEC60364-4-443
❖ Pollution degree 2
If the equipment is not used in the manner
described in this manual and with accessories
other than those recommended by Stuart, the
protection provided may be impaired.

electrical installation

tHiS inStRUMent MUSt Be eaRtHeD
Before connection please ensure that the
line supply corresponds to that shown on
the rating plate.
Model Supply requirements
HM50C 230V, 50/60Hz
HM100C 230V, 50/60Hz
HM250C 230V, 50/60Hz
HM500C 230V, 50/60Hz
HM1000C 230V, 50/60Hz
2
All models are supplied with two mains leads
fitted with IEC plugs for connection to the
instrument. One has a U.K. 3 pin plug and the
other has a 2 pin "Shuko" plug for connection
to the mains. Choose the lead appropriate for
your electrical installation and discard the other.
Should neither lead be suitable, take the lead
with the U.K. plug and replace the plug with a
suitable alternative. This involves cutting off the
moulded plug, preparing the cable and
connecting to the re-wireable plug in accordance
with its instructions.
tHiS OPeRatiOn SHOUlD OnlY Be
UnDeRtaKen BY a QUaliFieD eleCtRiCian
nOte: Refer to the equipment's rating plate to
ensure that the plug and fusing are suitable for
the voltage and wattage stated.
The wires in the mains cable are coloured as
follows:
BROWN
BLUE
GREEN/YELLOW - EARTH
The instruments are fitted with an IEC socket at
the rear of the instrument for connection of the
mains lead. The appropriate mains lead should
be connected BeFORe connection to the mains
supply.
Should the mains lead need replacement, a cable
of 1mm
to an IEC320 plug should be used.
iF in DOUBt COnSUlt a QUaliFieD
eleCtRiCian
Power
80W
80W
170W
220W
320W
- LIVE
- NEUTRAL
2
of harmonised code H05W-F connected