O Control; Data Input; Showdata; V:pad - Oase WECS II 2048/DMX/02 Gebrauchsanleitung

7 I/O Control
The DMX-Routing is one of the most powerful features of the WECS II 2048/DMX/02 Server. It gives you
the possibility to route DMX signals in any direction, from and to any source.
To open the configuration go to: "Settings > Input and Output Configuration" and select "I/O Control"
The I/O control offers you 8 free configurable setups called "Routing Lines". Each "Routing-Line" can be
used to route one DMX-Universe. As the graphic explains, all Data coming from the Left side are INPUTS
and on right side are OUTPUTS.
7.1

Data input

7.1.1

Showdata:

These are all Universes are internally calculated by the WECS II 2048/DMX/02 Server, so finally the
current running show.
7.1.2

V:PAD

Means all DMX data are currently sent by a potentially connected V:PAD. This is disabled by default.
This option is only used in some special cases i.e. where you want to keep control over a specific
universe using V:PAD (live). As soon as V:PAD is used as DMX-Input the V:Server will switch in
"Interface" mode and will simply forward all DMX-Data.
7.1.3

ArtNet:

Here you can merge in any ArtNET input, i.e. from an external console. Note that ArtNET Universes are
counting by 0.
7.1.4

Connectors:

Here you can define an physical DMX input connector to merge in. By default the Universe 1 is coupled
with the DMX-IN connector on backside. Here you can also change a DMX-Output connector to be an
Input (Gender changer needed) if you need more than one DMX-Input universe.
- EN -
29