Automatic On/Off - Peraqua SMART ECO Handbuch

It can be adjusted both when the machine is on or off.
A. Press UP-ALLOW key
pool water temperature.
B. The numbers in the LED screen will flash during your operation.
C. After five seconds, it will stop flashing and be saved, the LED screen will return to
the permanent display.
D.When you want to check the temperature, press UP-ALLOW key
DOWN-ALLOW key
3． Time setting
It can be adjusted both when the machine is on or off.
A. Press
B.Time on the LED screen flashes.
C. Press again then press
D. Before it stops flashing, press
E. After setting, press
will stop flashing and the LED screen will return to the permanent display.

Automatic on/off

This function can make the machine work or stop automatically in your required time.
1. Time on
A. Press
B. When the indicator light is on and the time is twinkling, press
Use
C. Before the twinkling stops, press
D. After adjusting, press "TIMER ON" and water temperature will be seen. 30
seconds later, the controller display will be back to the normal mode.
2. Time off
E. Press
F. When the indicator light is on and the time is twinkling, press
hour. Use
G. Before the twinkling stop, press
H. After adjusting, press
the controller display will be back to the normal mode.
3. Cancelling the automatic mode
I. Press
J. When the number is twinkling, press
LED shows water temperature, the timer on and off is canceled.
K. 30 seconds later, the controller display will be back to the permanent display.
again to get it.
key to set time according to your local time.
and the water temperature will appears. 30 seconds later, it
to set timer on.
and to adjust.
to set timer off.
and to adjust.
and water temperature will be seen. 30 seconds later,
or to cancel timer on and off.
or DOWN-ALLOW key
or DOWN-ALLOW key
and then press
to set minute .Use
to set minute .Use
. When timer indicator light is off and
to set to your required
to set hour.
or to set minutes
and
and
22
or
again to set hour.
to adjust.
again to set
to adjust.