Ruby Decor TFTT500 Montage- Und Bedienungsanweisung Seite 4

Remote Control Operation
Warning: It takes some time for the receiver to respond to the
transmitter. Do not press the buttons more than once within two
seconds for correct operation.
Setting Operation
Flame effect Press the 'I' button once
Flame effect & 750W heat Press the 'I' button again
setting
Flame effect & 1500W Press the 'I' button again
heat setting
To turn off any of the settings press the 'O' button once.
To increase or decrease the brightness of the fuel effect use the
buttons ' ' as shown in Fig. 3. Push the button constantly or several
times to see the effect.
Lamp Replacement
To gain access to the lamps
1. Remove the Front Cover by lifting up and out and carefully
leave to one side.
2. Remove the two screws on the fuel effect.
3. a) Lift one side of the fuel effect up first by holding the
front ledge,
b) and lift out gently, set aside carefully (taking care
not to damage the logs as they are fragile) – see Fig. 5.
4. For access to the bulbs, carefully rotate the flexible
rotisserie out of position ensuring that the rubber grommet
is not lost – see Fig. 6.
5. Unscrew the defective lamp anti-clockwise. Replace with
a 230V, 60W E14 SES lamp, do not over tighten (see
Fig. 6).
6. Refit the fuel effect (with two screws) and Front Panel.
Thermal Safety Cut-out
For your safety, this appliance has been fitted with thermal cut-out.
In the event that the product overheats, the cut-out switches the
heat off automatically.
To bring the heat back into operation, remove the cause of the
overheating, then unplug or turn off the electrical supply to the
heater for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch
on the heater.
Caution: In order to avoid a hazard due to inadvertent resetting
of the thermal cut-out, this appliance must not be supplied
through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off
by the utility
Cleaning and Maintenance
Warning: Always disconnect from the power supply before
attempting any maintenance.
Cleaning
Before commencing cleaning, unplug the heater and allow it to
cool.
The surface of the heater should be given an occasional wipe over
with a soft damp cloth. Do not use detergents abrasive cleaning
powder or polish on the body of the heater. The glass screen
should be cleaned carefully with a chamois leather. Do not use
proprietary glass cleaners.
- 2 -
Recycling
For electrical products sold within the European Community.
Indication
After Sales Service
Bottom Neon
Should you require after sales service or should you need to
Middle Neon
purchase any spares, please contact the retailer from whom the
appliance was purchased or contact the service number relevant
Top Neon
to your country on the warranty card.
Please do not return a faulty product to us in the first instance as
this may result in loss or damage and delay in providing you with
a satisfactory service.
Please retain your receipt as proof of purchase.
At the end of the electrical products useful life it should
not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or
retailer for recycling advice in your country.
UK