Remote Control; Using Batteries - VINCENT SV-123 Bedienungsanleitung

Point the front of the remote control directly at the
front of the appliance, making sure there are no ob-
jects between the remote control and the appliance.
The distance between the remote control and the
appliance should not be more than 7m, as the
reliability of the remote control is affected beyond

Using batteries

Handling batteries incorrectly can cause battery
acid to escape or an explosion in extreme cases.
The batteries must be correctly inserted taking note
of the polarity, which is marked in the inside of the
battery compartment. In order to make full use of
the batteries' life, do not mix new and used batte-
ries. Make sure that you insert batteries of the
same type. Some batteries are rechargeable,
others are not however. Take note of the precauti-
ons and instructions that are included on all batte-
ries. Remove the batteries if the remote control is
not going to be used for a long time. Under no cir-
cumstances must batteries be short-circuited, taken
apart or heated up. For environmental reasons,
used batteries should be disposed of in accordan-
ce with local environmental regulations and not put
with domestic waste.
Only use AA (LR6) size batteries.

REMOTE CONTROL

this range. Make sure that you do not point the
remote control at an angle to the appliance, as
beyond an angle of ±30° to the centre axis the
appliance may not respond as well to the remote
control. Change both batteries if the distance at
which the remote control can be used effectively
decreases.
BATTERIES
Changing/inserting batteries:
a. Open and remove the battery compartment
b. If necessary, remove used batteries and insert
c. Put the compartment cover back on and close
cover on the remote control by sliding the
cover on the underneath in the direction of
the arrow marked on it and then lifting it off.
new ones correctly as shown by the diagram
in the battery compartment.
new
old
the battery compartment.
a
b
c
Vincent
27