Power Cable - dB Technologies MOVING D Kurzanleitung

Picture 2.2
3 Connect the power cable and the XLR cables on the rear of TOURING RACK as shown in picture 3.1.
Note that the RPS10 leds blink and run for a few seconds, as shown in picture 3.2, and that HUB800
e MOVING D displays turn on, as shown in 3.3.
For further details refer to the RPS10 and MOVING D user's manual.

POWER CABLE

4 Verify the display of HUB800 is setting as shown in picture 4.1. Then start the autosetup
procedure, pushing first of all the "Down" button, then pushing the "Select" ribbon, as shown in
picture 4.2. Verify that the autosetup procedure is started, checking the display is setting as
shown in picture 4.3 . For further details refer to HUB800 user's manual.
www.dbtechnologies.com
Picture 2.3
XLR CABLES
Picture 3.1 – rear panel - perspective
Picture 3.2
MOVING D TOURING RACK – ENG - 6
info@dbtechnologies-aeb.com
Picture 2.4
Picture 3.3