Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DRYERDISPOSAL
This appliance is marked according to the European directive 2002/96/EC
on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed of correctly, you will help avoid potential negative consequences
for the environment
and
human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying
the product, indicates that this appliance may not be treated
as household waste. Instead it shah be handed over to the applicable collection
point for the recycling of electrica{ and
electronic equipment.
Disposal must be carried out in accordance
with local environmental
regulations for waste disposal.
For more detailed information
about treatment, recovery and recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased the product.
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
m 200 mm (8") or 250 mm
[]
8 mm (s/10")socket wrench
(10") Pipe wrench
[]
Utility knife
[]
200 mm (8") or 250 mm
[] Vent clamps
(10") Adjustable wrench
[]
Pipe-joint compound
[]
Flat-blade screwdriver
resistant to LP gas
[]
Phillips screwdriver
[]
Sealing gun and sealing
[] Adjustable
wrench that
compound (for installing
opens to 25 mm (1 ") or
new exhaust vent)
hex-head socket wrench
[]
Pliers
[]
Level
[]
Stiff-bladed
putty knife
Parts supplied:
Remove parts bag from dryer drum. Check that all parts were
included.
[]
Foot boot (4)
[]
Dryer foot (4)
NOTE: The circuit diagram for this dryer is located inside the
lower front panel, within the Tech Sheets.
Explosion Hazard
Keep flammable
materials and vapors, such as petrol,
away from dryer.
Do not install in a garage.
Failure to do so can result in death, explosion,
or fire.
If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
[]
Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages, closets, or sleeping
quarters. Contact your local building inspector.
[]
Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
"Recessed Area and Closet Installation Instructions" below
for minimum spacing requirements.
[]
Do not install on carpet.
NOTE: The dryer must not be installed in an area where it will be
exposed to water and/or weather.
Werbung
Inhaltsverzeichnis
