Weidmuller CP SNT 25 W 5 V 5 A Bedienungsanleitung Seite 37

2.3 Mounting instructions and tightening torques.
The device snaps onto mounting rails manufac-
tured to DIN EN 50022. They must be mounted
horizontally (connection terminals facing down).
Maintain a minimum clearance of 30 mm above and
below the device to meet heat dissipation require-
ments.
Caution: Depending on the surrounding temper-
ature and device load, the temperature of the
device housing can rise. Hot surfaces can cause injury.
Tightening torque:
Cross-section:
Insulation stripping length: 6 mm
4324050000/00/09.06
0.5 - 0.6 Nm
0.5 ... 4 mm ,
2
AWG 18 ... 12
37