Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pay attention towards the secure grip of the
screws.
Put the control panel back on the flush mount coiler
and tighten both of the unlosable screws back into
their sockets using a screw driver. Reinsert the screw
cover (fig. 12+13). Now put the plug into the socket.
The installation of the shutter strap motor is com-
plete.
The strap coiler may also be connected directly the
mains supply (p.3).
Installation of light sensor GWLS1 (accessory):
A light sensor incl. plug and approx. 1.3m of power cable are separately available.
In order to install the light sensor press down lightly on the grey cover of the control panel and pull it
back towards you (fig.14). Carefully put the plug of the light sensor on the six pins provided for in the
middle (fig 15+16); the cable must be showing towards the wall. Slide the grey cover back onto the
control panel. The light sensor cable may extrude from the cover either through the left- or right-hand
carving in the cover. Clean the window pane and position the light sensor onto the window pane as
desired. Information: The shutter strap motor will close the shutter after 15min of direct sunlight to the
position of the light sensor. In order to open/close shutter again, press corresponding button on the con-
trol panel; this may also be achieved by activated timer control. To remove or relocate the light sensor
only pull on the small plug (fig.17) of the transparent suction cup. Pulling/Pushing the white plastic
top may lead to destruction of light sensor.
14
709156-1GB
15
12
16
13
17
Werbung
