Product Description - Co/Tech As18B Original Bedienungsanleitung

Product description

Mini, oil-free piston air compressor with air regulator, suitable for supplying an airbrush
or other small spray gun with air.
1. Power switch
2. Carrying handle
3. Airbrush holder
4. Fine pressure adjuster
5. Output pressure gauge
6. Hose connection: 1/8" BSP
7. Air pressure regulator with filter
8. Water separator/trap
9. Ventilation opening
Operating instructions
1. Connect an air tool (brush/sprayer) to the air outlet connector (6) on the pressure
regulator (7).
2. Mix the paint to a suitable viscosity.
3. Plug the mains lead of the air compressor into a wall socket and set the switch (1) to
position 1 to switch the air compressor on. The compressor will start to compress
air straight away and continue to build up the pressure until it reaches 4 bar.
The compressor will start compressing the air again if the pressure drops to 3 bar.
4. Drain any water out of the water trap (8) by pushing up the water release valve at
the bottom of the water trap.
5. Always practice spray on a test object before spraying the subject to be painted.
- Practice on a similar surface first, set the air pressure
using the pressure regulator and plan your technique
before beginning work on the subject to be painted.
- To set the air pressure: lift the upper knob (4) on
the pressure regulator (7), turn it clockwise to increase,
or anticlockwise to decrease the output pressure.
Push the upper knob down to lock the setting.
4
2
5
1
6
7
8
5
3
9