myToys RC Buggy Aufbauanleitung Seite 8

EN
Commissioning
1. First move the switch on the bottom of the vehicle
to ON.
2. Then move the switch on the back of the remote
control to ON.
3. To establish a connection between the vehicle and the
remote control, then press the small lever down. If the
vehicle responds to this, the devices are connected to
one another.
4. If this is not the case after 8 seconds, switch off both
devices and repeat the switch-on and connection
process.
5. If the devices are correctly connected to one another,
they will also be so the next time they are switched on.
6. If several vehicles are used at the same time, please
make sure that they are put into operation one after
the other. Otherwise there may be faults when trying to
connect the vehicle and the associated remote control.
7. Steer the vehicle with the remote control by using the lever to move forwards and backwards
and the wheel to steer to the left or right.
Adjustable steering alignment on vehicle
The trim control dial is located between the front wheels. If the
vehicle begins to pull to the left, adjust the trim control towards
the "R" marking. If the vehicle pulls to the right while driving,
adjust the trim control towards the "L" marking..
8
left right
backwards
forwards
L R