Start-Up Of The Device/Introduction; Listening To The Radio - GPO PCD299 Betriebsanleitung

Start-up of the device/introduction

• Select a suitable location for the device, such as a dry, flat, non-slip
surface on which it is easy to operate the machine.
• Ensure that the device is sufficiently ventilated.
• Remove the protective film from the display if it is still present.
Power Supply
• Ensure that the voltage is the same as that indicated on the model
identification plate.
• Connect the power cable supplied (see battery compartment if
necessary) to a properly installed safety power socket and the mains
connector AC on the back of the machine.
Inserting the Batteries(not supplied)
1. Insert 6 batteries of type UM-2 ("C" size) 1.5 V. Please ensure that
the polarity is correct (see the floor of the battery compartment)!
NOTE:When a mains cable is connected the batteries are automatical-
ly switched off.
NOTE: After about 10 minute without a signal, the device will automati-
cally switch to standby.

Listening to the Radio

1. Turn the function selector switch to the RADIO position.
2. Select desired band by using the "BAND" selector.
3. Adjust radio frequency to your desired station by using the
"TUNING" control.
4. Adjust the "VOLUME" control to the desired level.
10