Initial Use - Princess 332833 Bedienungsanleitung

Congratulations!
You have purchased a Princess product. Our aim
is to provide quality products with a tasteful
design and at an affordable price. We hope
that you will enjoy this product for many years.
Description (fig. A)
Your 332833 Princess garment steamer has
been designed for steaming garments and
fabrics to remove creases. The appliance is
suitable for indoor use only. The appliance is
suitable for domestic use only.
1. On/off button
2. On/off indicator
3. Mains cable rewind button
4. Steam button
5. Steam indicator
6. Steam hose
7. Steam hose connection
8. Steam head
9. Steam head holder
10. Clothes hanger
11. Water reservoir
12. Water level indicator
13. Water filling point
14. Water drain point
15. Wheels
16. Fabric brush
17. Crease attachment
18. Lint brush
19. Accessory bag

Initial use

• Clean the appliance. Refer to the section
"Cleaning and maintenance".
Assembly (fig. B)
Before you proceed, we need you to pay
attention to the following notes:
- Before assembly, always switch off the
appliance and remove the mains plug from
the wall socket.
• Place the water reservoir (11) into the
appliance.
• Insert the telescopic poles (20) into the
appliance until they click into place.
• Insert the clothes hanger (10) into the
telescopic poles (20).
• Release the clamps (21). Set the lower
telescopic poles (20) to the required height.
Lock the clamps (21).
• Release the clamps (22). Set the upper
telescopic poles (20) to the required height.
Lock the clamps (22).
• Tighten the steam hose (6) onto the steam
hose connection (7).
• Hang the steam head (8) onto the steam
head holder (9).
Use
Filling the water reservoir (fig. B & C)
Before you proceed, we need you to pay
attention to the following notes:
- Before filling the water reservoir, switch off
the appliance and remove the mains plug
from the wall socket.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use the appliance without water in
the water reservoir.
- Do not exceed the maximum mark when you
fill the water reservoir. Make sure that the
water level is always above the minimum
mark during use.
- It is recommended to fill the water reservoir
with a mixture of 50% tap water and
50% distilled water in order to prevent the
formation of excessive limescale.
- Only use cold water to fill the water reservoir.
- Do not use carbonated water or other
liquids to fill the water reservoir.
• Remove the water reservoir (11) from the
appliance.
• Open the cover (23).
• Fill the water reservoir (11) through the
water filling point (13) with the required
amount of water:
- If you want to use the appliance for
40 minutes, fill the water reservoir up
to '40 min' mark on the water level
indicator (12).
13