Setup; Ac Power; Mounting; Orientation - Chauvet DJ Obey 4 Bedienungsanleitung

3. S
ETUP

AC Power

Mounting

Orientation

Installation

Fixture Addressing

3. Setup

This fixture runs on 12 VDC, 500 mA. Before powering on the unit, check the output of the power
supply to be sure that it is correct.
To determine the power requirements for a particular fixture, see the label affixed to the back
plate of the fixture or refer to the fixture's specifications chart. A fixture's listed current rating
indicates its average current draw under normal conditions.
·
Always connect the fixture to a switched circuit. Never connect the fixture to a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel
is used only as a 0 to 100% switch.
·
To eliminate wear and improve its lifespan, during periods of non-use completely
disconnect from power via breaker or by unplugging it.
·
Always connect the fixture to a circuit with a suitable electrical ground.
The Obey™ 4 may be mounted in any safe position.
Please see the drawing below, which shows the back of the controller. It details the dimensions
for mounting. This will aid in placing the holes for installation.
The Obey™ 4 can control up to 4 separate fixtures. Each fixture must be set to predetermined
DMX addresses. Please see the chart below for the DMX starting addresses of each of the four
<FIXTURES>.
Fixture 1: 1 - DIP switch assignment [1]
Fixture 2: 5 - DIP switch assignment [1, 3]
Fixture 3: 9 - DIP switch assignment [1, 4]
Fixture 4: 13 - DIP switch assignment [1, 3, 4]
9