Operational Summary; Battery Life Indicator; Inserting The Battery - Tasco VLRF 600 series Handbuch

OPERAtiONAL SUMMARY

While looking through the monocular, depress the power button once to activate the inview display system (LCD). Aim the tASCO LASER
RANGEFiNDER at a target at least 10 yards away, depress and hold the power button down until range reading is displayed. Release the power
button. Note: Once activated, the tASCO LASER RANGEFiNDER's LCD will remain active and display the last distance measurement for 30 seconds.
You can depress the power button again at any time to distance to a new target. As with any laser device, it is not recommended to directly view
the emissions for long periods of time with magnified lenses.
FEAtURES
Your tASCO LASER RANGEFiNDER's LCD incorporates illuminated indicators that advise you unit of measure, when the laser is active, the battery
charge is low, and when a target has been acquired. A summary of these features is presented below:

BAttERY LiFE iNDiCAtOR

Battery indicator: Within the display is a battery icon.
Full charge
2/3 battery life remaining
1/3 battery Life remaining
Battery indicator Blinks – Battery needs to be replaced and unit will not be operable

iNSERtiNG tHE BAttERY

Remove the battery cap by rotating the screw counter clockwise lifting the battery door. insert an Alkaline 9 volt battery into the compartment
and attach battery connectors.
NOtE: it is recommended that the battery be replaced at least once every 12 months.
Battery Life
indicator
Aiming Window
Laser Active
3