U.S. Robotics USR5436 Installationsanleitung Seite 9

Troubleshooting
For Macintosh and Linux assistance, refer to the Troubleshooting section in the User Guide on the
Installation CD-ROM.
My Setup Wizard can't detect the Wireless USB Print Server.
Possible Solution:
Check the physical connections between the Wireless USB Print Server, the printer, your wireless
or wired router, and your power adapters. Any loose connection could interfere with the detection
of the Wireless USB Print Server.
Possible Solution:
Refer to the LED descriptions at the beginning of this guide and then check the LEDs on the Wire-
less USB Print Server to make sure you are receiving power and that there is not an error.
Possible Solution:
Restore the factory default settings of the Wireless USB Print Server and repeat the installation
procedure. To restore the factory default settings, unplug the power supply of the Wireless USB
Print Server, press and hold in the Diagnostic button, and plug the power supply back in. Con-
tinue to hold in the Diagnostic button for 10 seconds to restore the factory default settings.
At the end of the Setup Wizard, I receive a message that says "Network
busy, or device not found".
Possible Solution:
On the main menu of the U.S. Robotics Installation CD-ROM, click Additional Installs and then
click User. Follow the on-screen instructions to continue the installation procedure.
My Wireless USB Print Server is not appearing in the Printer Port Setup
screen.
Possible Solution:
Check the physical connections between the Wireless USB Print Server, the printer, your wireless
or wired router, and your power adapters. Any loose connection could interfere with the detection
of the Wireless USB Print Server.
Possible Solution:
Refer to the LED descriptions at the beginning of this guide and then check the LEDs on the Wire-
less USB Print Server to make sure you are receiving power and that there is not an error.
Possible Solution:
Restore the factory default settings of the Wireless USB Print Server and repeat the installation
procedure. To restore the factory default settings, unplug the power supply of the Wireless USB
Print Server, press and hold in the Diagnostic button, and plug the power supply back in. Con-
tinue to hold in the Diagnostic button for 10 seconds to restore the factory default settings.
6