INTERTECHNO ITLR-3500 Bedienungsanleitung Seite 11

GB
Operating instructions
The remote adapters ITLR-3500 and ITLR-3500T are suitable for
wireless switching of lamps and electrical devices up to a switching
power of 3500 W.
The ITLR-3500T offers numerous capabilities with automatic switch-off of
7 sec up to 8 hr. Fig. 1
e.g: waste disposal unit, heat pump, lighting in entrance area, children's
bedroom, etc.
All intertechno transmitters are suitable for switching operations.
Please also observe the operating instructions for your transmitter.
The remote adapters ITLR-3500 and ITLR-3500T can also be switched on
and off at the learn button, without a remote control being necessary.
Encoding
Have your chosen transmitter ready.
Insert the remote adapter into the socket.
1.) Press the the Learn button (L) on the receiver (approx. 2 sec.) Fig. 2
until the red LED flashes slowly.
2.) Press the required button on the transmitter ("ON").
The remote receiver switches on twice to indicate that the new code has
been accepted.
DONE!
A maximum of 16 codes (transmitters) can be configured in total. This
also makes planned group activation very easy.
Several remote receivers can be switched on and off individually or
together.
Codes remain stored even after the device has been unplugged or if
there is a power failure.
GB
ITLR-3500(T)
How to erase codes
To erase an individual code on the receiver, proceed as in 1.) and 2.).
In this case, however, press the "OFF" button instead of the "ON" button
on the transmitter.
To erase all stored codes (reset), press and hold the learn button (L) until
the LED flashes quickly (approx. 6 sec).
Then, press the learn button (L) again briefly.
This erases all codes.
The transmitters are not required for this procedure.
Encoding with new transmitters can now commence.
To view the Declaration of Conformity, please visit
www.intertechno.at/CE
›
Operating instructions
ITLR-3500(T)