Suntec Wellness BBQ-9462 Bedienungsanleitung Seite 17

considerable dangers for the user.
• If the connection cable is damaged, it must be
replaced by a qualified person. Please contact your
point of sale.
• No liability is assumed for possible damage if the
device has been used for improper purposes, has
been operated incorrectly or has not been repaired
properly. In such a case, you have no warranty claim.
• When used as a table grill, please remove the hood
to avoid any tipping over.
• Children should be supervised to ensure that they
do not play with the appliance.
• Charcoal or similar combustible fuels must not be
used with this appliance.
Attention: Please be careful. Do not trip over the
power cord when the unit is in use. Please remember
to remove the plug after use.
Components of BBQ-9486
1. Grill hood
2. Hood handle
3. Grill plate
4. Grease collecting bowl
5. Base of appliance
6. Stand tube
7. Upper elbow pipe
8. Iron pothook
(The corresponding pictures can be found in the front of this manual.)
Installation of BBQ-9486
1. Please remove the trolley frame and the accessories from the box. Make sure that the trolley frame is
placed on a dry, level and stable surface. Insert the wheel axis (a) through the holes on the lower elbow
pipe (9) as shown in figure 1. Then attach the wheels (b) to both sides of the axis (a) as shown in figure
1.
2. There are two mounting holes on each side of the axis (a). Insert the R-Pin (C) through the holes to fix
the wheels. Then attach the wheel cover (d) to the wheels (b) (see figure 2).
3. Insert the upper elbow pipe (7) onto the lower elbow pipe (9). Fasten the screw (N1) from the outside
through the two tubes. Then tighten them with nuts and silicone washers. The "S" elbow pipe group is
completed (see figure 3).
4. Install the bracing sheet (g) on the upper elbow pipe (7) with bolts (N2) and nuts. Then install the stand
tube (6) on the upper elbow pipe (7). There is a positioning hole (I) on the stand tube (6) which is
attached to the base of the unit. Tighten the stand tube (6) to the trolley with screws and nuts (see figure
4).
5. Please assemble the two parts (10A) and (10B) to achieve the basket. Then attach the basket to the
outside of the set screws (N1). Attach the hook (8) to the tube of the trolley (see figure 5).
6. Place the base of the appliance (5) on the stand tube (6). Attach the bottom positioning projection from
the base to the positioning hole. When removing the foot from the stand tube (6), slightly step onto the
9. Lower elbow pipe
10. Hanging basket
11. Handle of base
12. Opening for appliance's socket
13. Detachable thermostat with cord
14. Temperature indicating lamp
15. Connecting socket