Windows Me Users - U.S. Robotics 7900 Installationsanleitung

Step 2. Install the driver
To install the necessary driver for the 10/100 Mbps Network Card, refer to the section for your spe-
cific operating system. Windows NT, 2000, and XP users must be in administrator mode to prop-
erly add any new hardware.
Windows 98 Users:
When Windows detects the new hardware, click Next. Select Search for the best driver for your
device (Recommended) and click Next. Insert the Installation CD-ROM into your CD-ROM drive.
Select Specify a location, type D:\ and click Next. If your CD-ROM drive uses a different letter,
type that letter in place of "D." When Windows locates the correct driver, click Next.
After the driver installation is complete, remove the Installation CD-ROM from your CD-ROM drive,
click Finish, and then click Yes to restart your computer. When the computer restarts, the installa-
tion procedure will be complete.
Windows NT Users:
Click Windows Start, Settings, and then Control Panel. Double-click Network and click the Adapt-
ers tab. Click the Add button and then click the Have Disk button. Insert the Installation CD-ROM
into your CD-ROM drive. Type D:\WinNT40 and click OK. If your CD-ROM drive uses a different let-
ter, type that letter in place of "D." When prompted, select the USR 10/100 Mbps Network Card
and click OK.
When the Speed/Duplex mode window appears, select (1) Auto and click OK. When the Input Net-
work Address window appears, click Skip. When the Input Tx Early Threshold window appears,
click Skip and then click Close. Remove the Installation CD-ROM from your CD-ROM drive. You will
then be prompted for the TCP/IP properties. Select the USR 10/100 Mbps Network Card from the
adapter pulldown menu.
Assuming you are connected to a network, if you know your IP settings, select Use the following
IP address and enter the information in the appropriate fields. Click OK. If you do not know your
IP settings, select Obtain an IP address from a DHCP server and click OK. Follow the on-screen
instructions. Apply any service packs or hotfixes before you reboot. Click Yes to restart your com-
puter.

Windows Me Users:

When Windows starts, it will detect the new hardware. Select Specify the location of the driver
(Advanced) and click Next. Select Search for the best driver for your device (Recommended) and
then select Specify a location. Insert the Installation CD-ROM into your CD-ROM drive. Type D:\
and click Next. If your CD-ROM drive uses a different letter, type that letter in place of "D." Follow
the on-screen instructions. When Windows locates the correct driver, select The updated soft-
ware (Recommended) and click Next. Click Next again and Windows will finish installing the
driver.
After the driver installation is complete, remove the Installation CD-ROM from your CD-ROM drive,
click Finish, and then click Yes to restart your computer. When the computer restarts, the installa-
tion procedure will be complete.
2