Philips AJ 3190 Bedienungsanleitung Seite 5

CLOCK
SETTING THE CLOCK
Important!
When setting the clock or alarm time, for
accurate hour and minute adjustment always
make sure you press the H
separately and not simultaneously.
Clock display
The time is displayed using the 24-hour clock
system.
1. Adjust the clock control to the TIME SET
position.
2. Press and hold down the H
to set and adjust both the hours and the
minutes.
– With your finger held down on H
hours will increase shown as a digit from
00 to 23
– With your finger held down on M
minutes will increase shown as a digit from
00 to 59
3. Release the H or M
R
have reached the correct setting.
4. To safeguard the clock time from being
accidentally adjusted, turn the clock control to
the RUN position.
RADIO
You can use this clock solely as a radio.
1. Set the RAD switch to ON.
2. Select your wave band using the BAND
switch.
3. Tune to desired radio station using the
TUNING knob.
4. Set the volume by turning the VOLUME control.
5. To turn off the radio, set the RAD switch to
OFF.
To improve radio reception
– For AM, (MW or LW ) the set is provided with
a built-in aerial which to function best should
be placed on a non-metallic surface e.g.
wood, plastic. Direct the MW aerial by
adjusting the position of your clock radio.
– For FM , extend the pigtail wire at the back of
the set completely for optimum reception.
RADIO
and M buttons
R IN
or M buttons
R IN
, the
R
, the
IN
buttons when you
IN
SETTING THE ALARM
General
If you wish to use the alarm, then you should
first set the alarm time. There is also the choice
of two modes for waking you up: by buzzer or
radio. The display will show the alarm indicator
in the bottom left corner if the alarm is set.
1. Adjust the clock control to the ALARM
position.
2. Press and hold down the H
to set and adjust both the hours and the
minutes.
– With your finger held down on H
hours will increase shown as a digit from
00 to 23
– With your finger held down on M
minutes will increase shown as a digit from
00 to 59
– If both the H and M
R
pressed simultaneously, the alarm time
display will be reset to 0:00.
3. Release the H or M
R
have reached the correct setting.
4. Adjust the clock control to the RUN position to
return to clock time display.
– To review your set alarm time, adjust the
clock control to the ALARM position.
5. To select the alarm mode you wish to be awoken
by, set the ALARM switch to
– If you have selected the radio mode, make
sure you have adjusted the volume loud
enough to wake you.
– The buzzer is at a set volume and cannot be
adjusted.
ALARM
or M buttons
R IN
, the
R
, the
IN
buttons are
IN
buttons when you
IN
or .
RAD BUZ
5