Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
MAINTENANCE
• Under normal conditions, periodically flushing the nozzle with clean water and cleaning grit and dirt from around exterior moving
parts will allow the nozzle to operate as designed .
• Periodically (at least annually), lubricate the pattern sleeve with Low-Temp Lubripate by using the grease fitting on the side of the
pattern sleeve .
• Over time the O-Rings may need to be replaced. This can be accomplished by purchasing the appropriate O-Rings shown on the
service parts list. Use qualified maintenance mechanics or return the nozzle to Akron Brass for repair.
ISO 9001 REGISTERED COMPANY
• Controls that are either inoperable or difficult to operate.
• Excessive wear.
• Poor discharge performance.
• Water leaks.
If any of the above situations are encountered, the nozzle should be taken out of service and repaired, plus
tested by qualified nozzle technicians, prior to placing it back in service .
• To change the spray angle rotate the pattern sleeve. Rotate it clockwise for straight stream and
counterclockwise for wide fog . The Style 4460 has a detent at the straight stream position .
• To shut off the Style 4460, rotate the pattern sleeve clockwise slowly until it shuts off.
• To change the 750 gpm flow rate, remove the bafflehead and .118" thick spacer and install the 1000 gpm
spacer (.218" thick) or use no spacer for 500 gpm.
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship. Akron Brass will repair or replace product
which fails to satisfy this warranty . Repair or replacement shall be at the discretion of Akron Brass . Products must be promptly returned to Akron Brass for warranty service .
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow
our instructions or recommendations; or anything else beyond our control. WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY STATEMENT,
AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. Further, we will not be responsible for any consequential, incidental or
indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever . No person has authority to change this warranty .
© Akron Brass Company . 2011 All rights reserved . No portion of this can be reproduced without the express written consent of Akron Brass Company,
PHONE: 330.264.5678 or 800.228.1161 I FAX: 330.264.2944 or 800.531.7335 I akronbrass.com
revised: 8/11
Werbung
