electia protect EL-20 Bedienungsanleitung Seite 16

Register detector:
Press the SET button for about 3 seconds until E1 appears on the LED display and
then press SET one more time to see 01 appear on the display. Send a read signal
from the detector. If another remote control is to be registered, press NEXT and
02 appears on the display. Send read signal etc. End the reading by pressing the
SET button once. Otherwise, the process is the same as the registration of a remote
control.
8 remote controls,
The siren as a repeater
2 NC type wired zone interfaces. Zone No.1 for
First, turn the siren's switch repeater on (move the jumper to ON). Then, press the
buttons SET and NEXT simultaneously for about 3 seconds until you hear a short
sound. Address 01 appears on the display. Send a read signal from the remote
control or detector. For additional reading of sensors. Press Next and address 02
appears on the display etc. End the reading process by pressing the SET button
once. Clear the address (sensor) by pressing and holding the NEXT button for at
least 3 seconds until you hear two short sounds.
12V/1.2A Lead-acid battery, up to
Repeater
Working mode
FUNCTIONS:
• Connected as additional siren for alarm system EL-20.
• Stand-alone alarm with 8 remote controls and 32 detectors.
• Can be used as a repeater.
• 2 x wired inputs for 24h and burglary sensors.
• Tamper and low battery alarm.
• 2 different types of alarm sound.
• Siren sound 120 dB.
32 wireless accessories.
32 detectors.
24
OFF ON
REPEATER
RED/BLUE RED BLUE
Red/ Blue/ Red+Blue
24 hours defend and zone No.2
hours of sand-by time
6
)
Setting button / set
Select / delete button / next
Code button / enroll