Axis T91A61 Installationsanleitung Seite 6

Page 6
Install the AXIS T91A64 Corner Mount
1. Refer to Hardware overview, on page 4 for information on the supplied
parts.
2. Attach the corner bracket in the desired position using screws that are
appropriate for the wall material and the weight of the camera and
bracket.
3. Attach the wall bracket holder to the corner bracket using the supplied
screws.
4. The wall bracket can temporarily be hooked on the wall bracket holder, in order to easily route
the cable through the bracket (fig 1 & 2):
fig. 1
Tabs
Slide bracket between the
tabs on the bracket holder
5. Route the network cable through wall bracket, securing it in the cable holder (fig. 3).
6. Press the locking tab and unhook the wall bracket from the temporary position (fig. 2).
7. Use the supplied screws to secure the wall bracket to the wall bracket holder.
8. Refer to the Installation Guide for the network camera for instructions on how to attach the
camera to the bracket.
fig. 2
Swing wall bracket
to the side for
temporary support
fig. 3
Cable
Cable
holder
AXIS T91A Installation Guide
Locking tab