Herunterladen Diese Seite drucken
Vorschau ausblenden Andere Handbücher für DMI-2 portable:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

georg neumann gmbh · ollenhauerstr. 98 · 13403 berlin · germany
tel +49 (0)30 / 41 77 24-0 · fax -50 · headoffice@neumann.com · www.neumann.com
DMI-2 portable
Bedienungsanleitung
Operating Manual
Registrieren Sie bitte Ihr
System auf der Website
www.my-Solution-D.com,
um über Updates informiert
zu werden!
Please register your system
on the website
www.my-Solution-D.com,
to be informed whenever updates
are available!
2
10

Werbung

loading

Inhaltszusammenfassung für Neumann.Berlin DMI-2 portable

  • Seite 1 DMI-2 portable Bedienungsanleitung Operating Manual Registrieren Sie bitte Ihr System auf der Website www.my-Solution-D.com, um über Updates informiert zu werden! Please register your system on the website www.my-Solution-D.com, to be informed whenever updates are available! georg neumann gmbh · ollenhauerstr. 98 · 13403 berlin · germany...
  • Seite 2 Mikrofone sowie die direkte Steuerung die dem Standard AES42 entsprechen. gültiges Synchronisationssignal am DMI-2 porta- bestimmter Mikrofonparameter (z.B. Preattenua- Das DMI-2 portable ist ein Speise- und Steuerge- Beim Anschluss anderer digitaler Signalquellen ble angeschlossen wurde. Ursache: keine gültige tion, Lowcut).
  • Seite 3 Jitter-Unterdrückung führt. stratorrechte erforderlich. Am DMI-2 portable angeschlossene Mikrofone DMI-2 portable- • Das DMI-2 portable darf erst mit einem USB- müssen immer im Synchronmodus betrieben wer- Synchronisation ........automatisch AES42 IN Port des Computers verbunden werden, nach- den, unabhängig davon, ob in der nachfolgenden...
  • Seite 4 Informationen vorgesehen. Im Standard AES42 (PC/Mac) nötig ist. sind diese Userbits in ihrer Bedeutung für digitale Mikrofone defi niert. Im DMI-2 portable werden di- Dies geschieht auch, wenn ein Mikrofon erst spä- ese Daten vom Audiosignal getrennt und über die ter an das schon eingeschaltete DMI-2 portable Steuerschnittstelle (USB) zum Computer geleitet.
  • Seite 5 Fehlercheckliste ▶ ▶ Fehler Mögliche Ursachen Abhilfe Ein am DMI angeschlossenes und DMI wird von der RCS Software eingeschaltetes Mikrofon wird an nicht erkannt – Ursache: der RCS nicht angezeigt, obwohl Das DMI war beim Starten der RCS RCS erst starten, nachdem das LED „VALID“...
  • Seite 6 (e.g. preattenu- The DMI-2 portable provides power and remote crophones in accordance with to the international DMI-2 portable; this may be due to an invalid ation and lowcut). control for digital microphones that operate in standard AES42 and makes the microphone signal word clock frequency (+/–50 ppm) or to excessive...
  • Seite 7: Equipment Supplied

    176.4 / 192 kHz Updating of fi rmware This ensures loading of the supplied USB driver. Microphone The fi rmware in the DMI-2 portable and in the AES/EBU OUT synchronization: ......AES42 – Mode 2 Neumann microphones is updatable. Updates can...
  • Seite 8: Additional Information

    NP1 rechargeable battery or with +10 V and max. 250 mA. Modulation of the upon the technical features of the subsequent ator of the DMI-2 portable can be used to synchro- AC/DC converter (Sound Devices phantom voltage generates a remote control data equipment.
  • Seite 9: Troubleshooting

    Troubleshooting ▶ ▶ Problem Possible causes Solution The RCS does not indicate that a The DMI is not recognized by the microphone is switched on and RCS software. – Cause: connected to the DMI, even though The DMI was not switched on Do not start the RCS until the DMI the “VALID”...
  • Seite 10 Word Clock Receiver Digital AES42 AES/EBU Mic. (e.g. Mix. Console) Control Data + Control Data Control Bus DPP(+10V) Abb. 1 / Fig. 1 Control Device (Computer) Abb. 4 / Fig. 4 Abb. 2 / Fig. 2 Abb. 3 / Fig. 3...
  • Seite 11 Haftungsausschluss Konformitätserklärung Die Georg Neumann GmbH übernimmt keinerlei Haftung für Folgen eines Die Georg Neumann GmbH erklärt, dass dieses Gerät die anwendba- unsachgemäßen Gebrauchs des Produkts, d.h. die Folgen eines Gebrauchs, ren CE-Normen und -Vorschriften erfüllt. der von den in der Bedienungsanleitung genannten technischen Vorausset- ®...