Marmitek PowerMid Plus Bedienungsanleitung Seite 10

6) Manual code search
If your equipment (TV, SAT etc....) does not respond, try the other codes for your brand. If it
still doesn't respond, try the Code Search method.
If you wish to dedicate another appliance to the VCR, DVD, SAT, CBL or CD keys you need
first to enter the 3 digit code of an appliance similar to the appliance you want to control. i.e.:
to search for a SAT code first enter the code (found in the code book) of any SAT as described
in § 5. Then follow the steps below :
1. Make sure your equipment is switched on. If not switch it on manually
2. Press and hold SETUP (4) until the LED indicator lights steadily. Release SETUP.
3. Press the mode key (5) that matches the equipment you want to control (i.e. TV).
4. Press Channel +(14) repeatedly until the channel changes. If you step past the correct
code, use Channel - (14) to go back to the right code
5. When the equipment you want to control reacts press ENT (11) to confirm the code.
Note : If your equipment doesn't have Channel + you can use PLAY (VCR or DVD) (21) or
POWER (2) key
The search starts after the last registered code. If that was 030, the search starts at at 031
until the last possible code and then goes from 000 to 029.
Note : if certain functions of your equipment can't be controlled you have to find a different
code for your brand
7) Automatic code search
When searching an unknown code, you can step through the library automatically
(AutoSearch). When your equipment responds, you can stop the searching process and
store the code you found.
If you wish to dedicate another appliance to the VCR, DVD, SAT, CBL or CD keys you need
first to enter the 3 digit code of an appliance similar to the appliance you want to control. i.e.:
to search for a SAT code first enter the code (found in the code book) of any SAT as described
in § 5. Then follow the steps below :
1. Turn on the device you want to control.
2. Press and hold SETUP (4) until the LED indicator (1) lights steadily. Release SETUP.
3. Press the mode button (5) that matches the equipment you wish to control. The LED (1)
blinks once.
4. Press CHANNEL+ (14) once. After a few seconds the remote starts stepping through the
code library (fast search, 1 code per second). When the device responds, you can press
CHANNEL+ (14) to switch to slow search (1 code per 3 seconds). You can step back by
pressing CHANNEL- (14) (you can step forward by pressing CHANNEL+(14) in case you
went too far back). As soon as the device responds again, press the ENT key (11) to
store the code you found.
8) Identifying codes found using the search procedure
1. Press and hold SETUP (4) until the LED indicator (1) lights steadily. Release SETUP
2.Press the mode key (5) for the equipment you want to identify (TV, VCR, DVD, SAT, CD,
8