Grizzly H6151 Bedienungsanleitung

Introduction
The Model H6151-54 provides a strong air and
water tight seal using polyethylene or polypropyl-
ene plastic bags.
Specifications
Model H6151
Power
200W
Seal Length 100mm 200mm 300mm
Seal Width 2mm
Seal 0.2mm
Thickness
Heating
0.2-1.5
Time
(sec)
Dimensions
24 x 9
x 16cm
Weight
1.8kg
Inventory (Figure 1)
A. Heat Sealing Machine ............................... 1
B. Teflon Fabric Strips .................................... 2
C. Heating Elements ....................................... 2
A
Figure 1. Model H6151 inventory.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
H6152 H6153 H6154
300W 400W 1000W
400mm
2mm 3mm
0.3mm 0.4mm 0.4mm
0.2-1.5 0.2-1.5 0.2-2
(sec) (sec)
8 x 32 8.2 x 45 9.2 x 56
x 15cm x 18cm x 18cm
2.7kg 4.5kg 5.5kg
Qty
C
B
COPYRIGHT © APRIL 2007 BY GRIZZLY INDUSTRIAL, INC.
#BL9116 PRINTED IN CHINA
MODEL H6151-54
HEAT SEALING
INSTRUCTION SHEET
Operation
1. Remove the shipping brace, place the sealer
on a level surface and connect it to a 110V
AC power source.
2. Adjust the dial on the sealer (see Figure 2)
according to the thickness and type of plastic
bag.
Use a higher indicator setting for thick mate-
rial and a lower setting for thin material.
3mm
Arm
(sec)
Figure 2. Model H6152 identification.
3.
Open the arm, place the shortest width of the
bag across the teflon strip and press the arm
down. The red indicator light will illuminate.
Note: The sealer will not turn ON until you
press the arm down. Therefore, you can leave
it plugged into power between uses.
4. After the red light turns off, wait a second
for the seal to cool, then raise the arm and
remove the bag.
MACHINES
Indicator
Light
Teflon
Strip
Dial