Werbung
5.
Check the seal.
— If the sealer leaves a 2-3mm wide band
across the bag, the dial setting is correct.
—If the sealer did not leave an evenly
melted band across the bag, go to the
Troubleshooting section.
Accessories
Grizzly carries bags for the Model H6151-54:
H7291—Plastic Roll, 4" x 2",150' x 2mil
H7292—Plastic Roll, 8" x 2,150' x 2mil
H7293—Plastic Roll, 4" x 1,075' x 4mil
H7294—Plastic Roll, 8" x 1,075' x 4mil
H7295—Plastic Bag, 4" x 6" x 2mil, 100 Count
H7296—Plastic Bag, 5" x 8" x 2mil, 100 Count
H7297—Plastic Bag, 9" x 12" x 2mil, 100 Count
H7298—Plastic Bag, 14" x 16" x 2mil, 100 Count
H7299—Plastic Bag, 9" x 12" x 4mil, 100 Count
H7300—Plastic Bag, 14" x 16" x 4mil, 100 Count
Grizzly cannot guarantee the compatibility of bags
sold by other companies with the Model H6151-
54.
Maintenance
Occassionally the sealer will require cleaning.
1.
DISCONNECT THE SEALER FROM THE
POWER before performing maintenance!
2.
Use an eraser, a dry cloth or a finger to
remove residue from the top teflon strip and
the rubber strip on the arm. Do not use sol-
vents.
Service
If the teflon strips become torn replace them and
the heating element.
To replace the teflon strips and heating ele-
ment:
1.
DISCONNECT THE SEALER FROM THE
POWER!
2.
Remove the metal plates, the teflon strips
and the heating element. On Model H6151
and H6152, remove the screw at the front of
the sealer that secures the heating element
(see Figure 3).
-2-
Figure 3. Teflon strips and heating element,
Model H6151.
H6151-54 Heat Sealing Machines
Werbung
