Hobbywing Technology EZRUN Bedienungsanleitung Seite 13

throttle range with a Futaba
A) Switch off the ESC, turn on the
transmitter, set the direction of throttle
channel to "REV", set the "EPA/ATV"
value of throttle channel to "100%", and
disable the ABS function of your
transmitter.
B) Hold the "SET" key and then switch on
the ESC, and release the "SET" key as
soon as possible when the red LED
begins to flash. (Note2 )
Note2:
If you don't release the "SET" key as soon as the red LED begins to flash, the ESC will enter the program mode,
in such a case, please switch off the ESC and re-calibrate the throttle range again from step A to step D.
C) Set the 3 points according to
the steps shown in the pictures
on the right side.
1) The neutral point
Move the throttle stick at the
neutral point, and then click the
SET key, the
flashes 1 time.
2) The end point of forward
direction
Move the throttle stick at the
end point of forward direction,
and then click the SET key, the
green LED flashes 2 times.
3) The end point of backward
direction
Move the throttle stick at the
end point of
direction, and then click the
SET key, the
flashes 3 times.
D) Throttle range is calibrated;
motor can be started after 3
seconds.
3. Check The LED Status In Normal Running
► Normally, if the throttle stick is in the neutral range, neither the red LED nor the green LED lights.
► The red LED lights when the car is running forward or backward and it will flash quickly when the car is braking.
► The green LED lights when the throttle stick is moved to the top point of the forward zone.
4. Check The Lipo Cells Setting If You Are Using Lithium Battery
If you are using Lipo battery, we strongly suggest setting the programmable item # 11 --- "Lipo Cells" manually to avoid
the over-discharge problem. Please read the instructions on page 2.
In normal case, when the ESC is switched on, the motor will emit several "Beep" tones to express the cells amount of the
battery pack. For example, "Beep-Beep-" means 2S Lipo, "Beep-Beep-Beep-" means 3S Lipo, etc.
【PROGRAMMABLE ITEMS LIST】(
P ro g ra mm ab le
Ite ms
B as ic Ite m s
1. R unning Mode
2.D rag Brak e Force
3.Low Voltage
C ut-O ff Threshold
4.Start Mod e(Punc h)
EZRUN Serie
TM
transmitter.
green LED
backward
green LED
The italics texts in the above form are the default settings
1 2
F or ward /Rev erse
Forward
w ith Brake with B rake
0% 5%
N on-Protec tion 2.6V/C ell
Lev el1 Level2
P ro g ram m ab le V alue
3 4
F orward and
Re vers e
10% 20%
3.0V
2.8V/C ell
/C ell
Level3 Level4 L evel5
www.hobbywing.com.de
)
5 6 7 8
40% 60% 80% 100%
3.2V
3.4V
/Ce ll /Cell
Lev el6 Level7 Level8
9
Level9
Seite 13