Call Abort; Event Log; Acknowledgment Options - Farnell SD1+ Bedienungsanleitung

Call abort

The SD1+ can be programmed so that if an alarm is accidentally triggered the alarm
call can be aborted in the following ways: 1) by activating a signal at the ABORT TRIG
input if it has been programmed for this; 2) by clearing the signal at an alarm input; 3)
by entering a valid passcode.
been carried out. Please refer to page 13 for further information.

Event log

The SD1+ has an event log which tells you which recipient acknowledged the last alarm
call. Please refer to page 14 for further information.

Acknowledgment options

When an alarm input is triggered, the SD1+ immediately begins calling the pro-
grammed numbers and plays the recorded messages. To stop this procedure, the
person answering the call must acknowledge the alarm call by pressing
telephone handset. There is also the option that all target numbers must first be dial-
led. For more information about options see page 15.
Alarm phone numbers
The SD1+ can dial up to four different numbers when there is an alarm. Each one can
have a maximum of 24 digits and can be easily programmed using the keypad. The
SD1+ supports both pulse and tone dialling. For more information see pages 16 - 18.
6
ABORTED
shows in the display to confirm the abort has
8
on the