Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ASSEMbLING INSTrUcTION
fITTING Of SPINWOrX
In order to maintain optimum and safe use of these tools, you should pay attention
to following notice:
STEP 1: PLAcING INSErTS INTO ThE SEAT
Place the inserts (1) into the seat provided. App-
ly the paste included (4) to the thread of the pin
(2) and make sure no paste (catalogue number
„Z 00043") gets onto the contact surface.
Remove any surplus before using the tool.
STEP 2: INSErTING ThE PIN
Insert the pin (2) into the screw attachment
from behind and use the torque key to tighten
according to the specified tightening torque.
We recommend using our pre-set torque keys.
TIGhTENING TOrqUES
Torx
Insert
size
DR7-8...
T6
DR10-8...
T10
DR12-8...
DR16-8...
T20
DR20-8...
Pokolm
frästechnik Gmbh & co. KG
Adam-Opel-Straße 5
33428 Harsewinkel
Germany
fon: +49 5247 9361-0
fax: +49 5247 9361-99
info@pokolm.com
www.pokolm.com
INSErTS IN ThE TOOL
®
Insert (1)
Tightening
torque
0.5 Nm
1.4 Nm
2.5 Nm
Paste (4)
Pre-set Torque
key (3)
Pin (2)
Werbung
