Troubleshooting; Packing Content - auna multimedia 10005060 Anschluss- Und Anwendungshinweise

Geometry Menu
H-position 0~100
V-position 0~100
CLOCK 0~100
PHASE 0~100
Note: The geometry menu only exists in PC channel.
Problem
When turn on the power
switch, the indicator light do
not work.
The remote control cannot turn
on the projector.
No image in the screen.
Auto-off after use some times.
Projector 1 unit
Remote control 1 pc
Power cable 1 pc
AV cable 1 pc
VGA cable 1 pc
Manual 1 pc
Spare fuse 1 pc
Clear paper 1 pc
Position in horizontal
Position in vertical
Scan frequency in horizontal
Adjust the signal synchronisation

Troubleshooting

Possible Solution
Power cable do not connect well.
The power switch fuse is broken
The power switch turn on or off?
Remote control do not have battery.
The remote control do not aim at the IR point
The input source choice is correct?
Is there a input signal?
The input cable connect well or not
Under PC mode:
The PC output frequency is 50-60 Hz?
The projector ventilation is block?
The Voltage is not stable.
The projector is so hot? Maybe the fan is broken.

Packing Content

22