NINCOAIR NH90045 180 SWIFT G Handbuch Seite 5

TRANSMITTER
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1.- Open the battery covers.
2.- Fit the batteries (respect polarity).
3.- Close battery covers.
Helicopter:
There are two ways to charge the battery:
1) Connect the USB cable to the USB port of a computer (preferably) or a wall charger (not included). Connect the
charging plug into the battery.
2) Open the front cover of the transmitter and connect the battery.
Approximate charging time: 20 minutes.
HELICOPTER FLIGHT
Before flight:
1.- With the helicopter battery disconnected,
the transmitter .
2.- Connect the helicopter battery.
3 .- Place the helicopter on the ground (very important for the operation of the gyro), with the tail pointing toward you.
4. Synchronizing transmitter and helicopter: Full push the left stick for a second, then pull back.
Trim adjustments:
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Press it left or right until the helicopter stops turning.
Dual rate. User-level:
The user has Beginner (70%) or Advanced (100%) control depending on your piloting skills. Use the switch on the right to change level. Advanced
is ideal for experienced riders. Beginner choice is recommended if it is the first flight of the user, since it is slow and progressive movements.
select the band in the transmitter A, B o C and the helicopter will automatically identify it.
Switch ON the helicopter.
NINCOAIR is brand of NINCO DESARROLLOS S.L.
08940 Cornellà - Barcelona - Spain
CIF B-60307725 - www.nincoair.com
5
Crta. de L'Hospitalet 32
HANDBOOK
ENGLISH
Dual rate.
Speed control
Switch ON