Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting instructions
S0-S-BUS modules snap onto tophat rail, according to
DIN 50 022 (35 mm).
Important instructions
Safety
Check compliance with nominal voltage before commis-
sioning the device (see type label). Check that connection
cables are free from damage and that, when wiring up the
device, they are not connected to voltage.
Cleaning
Modules can be cleaned with a dry cloth, or a cloth
moistened with a soap solution. Never use corrosive
substances, or products containing solvents.
Maintenance
S0-S-BUS modules are maintenance-free. If damaged
during transportation or storage, no repairs should be
undertaken by the user.
Guarantee
Opening the module invalidates the guarantee.
Saia-Burgess Controls AG
Bahnhofstrasse 18 I CH-3280 Murten I Switzerland
T +41 26 580 30 30 I F +41 26 580 34 99
support@saia-pcd.com I www.saia-pcd.com
4 319 5039 0e
Subject to change without notice
Hook S0-S-BUS module
onto the DIN rail
Hook top section of hous-
ing onto the DIN rail
Press lower section
of housing against the
mounting surface until it
clicks in.
For safety, push housing
down from above into the
DIN rail.
Removal from rail
Simultaneously pull down
the latch at the bottom of the
housing and pull bottom of
housing away from mount-
ing surface.
04.2015
Werbung
Inhaltsverzeichnis
